Follow

GN Netcom GN 9120 DG pairing guide

Step 1: Put your phone into registration mode

Locate the page/intercom/find button  on your phone’s base unit (this is the bigger unit which is plugged into your phone point).

Push the button and hold it for 3-5 seconds –you may hear a beep or a pulsing sound after doing this (depending on the model of the phone). The phone is now in registration mode and ready to be registered with the headset.

Step 2: Registering the headset

Push  all three buttons on the headset together and hold them for 6 seconds. Then release it and wait around 60 seconds, the registration is being done.


Your headset and phone should now be registered and you should hear a dialing tone when using the headset.

For incoming calls you would simply need to press the answer button on the headset to answer/end the call.

To make an outbound call using the headset, you need to make the call on your cordless handset and then transfer the call to your headset. Please refer to the manual for this process (this is the same as transferring a call from one handset to another).

Was this article helpful?
2 out of 2 found this helpful
Have more questions? Submit a request

7 Comments

Please sign in to leave a comment.
Powered by Zendesk