Follow

How to register an RTX Repeater

 

Extending the range of your cordless phones with the RTX repeater is made easy, with our handy guide for registration.

If you have already tried to set-up your repeater unsuccessfully, please reset your repeater (by plugging it in for 5 seconds, removing for 5 seconds, plugging it back in for 30 seconds, and then removing it) before moving on to the steps provided below. You will need to carry out this procedure in the vicinity of your cordless phone’s base station (main unit connected to your phone line):

For registering the RTX repeater with Gigaset phones:

1Disable ECO mode

  • From the handset, press the menu button or the centre of joystick then follow the sequence below:
  • Go to SETTINGS → BASE or SYSTEM → (ADD. FEATURES*) → ECO MODE → OK or no tick (TO DISABLE ECO MODE)

2 Enable Repeater support

  • Follow Step 1 to access the SETTINGS and follow the sequence below:
  • Go to SETTINGS → BASE or SYSTEM → (ADD. FEATURES*) → REPEATER MODE → YES or a tick (TO ENABLE REPEATER SUPPORT)

3 Put your phone into registration mode and register the repeater

  • Locate the page/intercom button on your phone’s base unit (this is the bigger unit which is plugged into your phone point). Press and hold the button for 3 seconds – you may hear a beep after doing this (depending on the model of the phone). The phone is now in registration mode and you will have 5 minutes to register the repeater.
  • Insert the repeater’s power plug for 1-2 seconds in the socket and then remove it. Insert it once more and leave it there. The LED on the repeater should now flash very quickly without interruptions.
  • On your handset, press (2) on the keypad and then the green answer button. The repeater’s LED will flash a corresponding number of times. Accept the registration by pressing the (*) key on the handset and wait until the dial tone cuts out. ^


The LED should go off for 2 seconds, flash for a brief moment and then remain continuously illuminated. This means the repeater is now registered.

For registering the RTX repeater with all other models:
1 Put your phone into registration mode

  • Locate the page/intercom/find button on your phone’s base unit (this is the bigger unit which is plugged into your phone point).
  • Push the button and hold it for 3-5 seconds – you may hear a beep or a pulsing sound after doing this (depending on the model of the phone). The phone is now in registration mode and ready to be registered with the repeater.

2 Registering the repeater

  • Insert the repeater’s power plug for 2-3 seconds in the socket and then remove it. Insert it once more and leave it there. The LED on the repeater should now flash very quickly without interruptions.
  • The registration should take up to 1 minute to complete.


When the LED on the repeater stops flashing and has a constant red light, this means the repeater is now registered.

If this fails to work, try resetting the repeater and going through the procedure again. Alternatively, contact our highly-trained Customer Service staff for further support.

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

10 Comments

Please sign in to leave a comment.
Powered by Zendesk